Sun 23 Feb, 2014 01:38 am - Well I found out that the fourth cycle of the regeneration was way to short and had to increase it to 50 minutes. It must have changed from an extended power outage here.
And I found out that the... (view)
Sun 23 Feb, 2014 01:19 am - I was able to change the settings to regen after 490 gal used.
But I was not able to increase the amount of resin to 1 cu ft because the tank is too small. .75 cu ft is the limit for that size... (view)
Sat 22 Feb, 2014 03:46 pm - To clarify my previous reply, mine is the aqc 50 gold series.
It has .50 cu ft of ion exchange resin x100.
It has a .25 brine restricter in the brine line which yields .25 gal per min brine fill.... (view)
Sat 22 Feb, 2014 01:53 pm - .50 cu ft of resin wasn't enough so I changed it, now .75 cu ft.
Since I only use 70 gal of water per day with 25 gpg hardness I set it up for better efficiency/ lower salt dose by running it... (view)
Fri 24 Jan, 2014 03:20 am - Some softers make brine after regenerating for the next regen, so in that case it would be normal.
Don't know about your type though . (view)
Tue 21 Jan, 2014 07:50 pm - I've tried in vane to get this PDF. After fruitless hours trying to crack this code I had a break through regarding the cycles and the times for each.
It is possible to toggle through each... (view)
Tue 21 Jan, 2014 03:43 pm - I have the gold series (digital)and it cycles like this:
1 eleven min fill brine tank
2 twenty min+ninety nine min waiting for brine creation
3 ten min back wash
4 fifty min brine draw/slow... (view)
Mon 20 Jan, 2014 10:12 pm - 1 Could you tell me how to change the settings for how much gallons used between regeneration? I think it is set to high. I only use 490 gal per week on average and need to soften 2000 grains per... (view)
Mon 20 Jan, 2014 08:37 pm - That problem was solved by increasing the slow rinse cycle from 17 min to 50.
Can someone tell how much capacity this unit has if the tank size is 8x43 with .5 cubic foot of x100 resin?
I need... (view)