Reply
Sun 24 May, 2015 08:35 am
I entered manual mode #3 which normally steps through the cycle, but instead it keeps running and only displays a 5 for step 5 which was the last step it paused for. How do I return to stepping through the cycle? Going into Diagnostic or Normal mode does not have any effect.
@Casmithq2,
if the drive motor is running all the time and the white cams aren't turning the you need a shear pin and orings replaced. if the cams are turning you have a bad switch or loose connecter on a camswitch.
Stumble It!
Tweet This
Bookmark on Delicious
Share on Facebook
Share on MySpace