1
   

ecowater systems

Forums: Water Softeners
Email this Topic • Print this Page
 
 
t1967
 
Reply Sun 3 Nov, 2013 06:27 pm
My power went out and now my circuit board shows all black rectangles no data and the water is back flushing continuously. Help
  • Topic Stats
  • Top Replies
  • Link to this Topic
Type: Question • Score: 1 • Views: 657 • Replies: 1
No top replies

 
DIDS007
 
  1  
Reply Thu 7 Nov, 2013 08:37 am
@t1967,
Check the transformer for proper voltage (between 24 and 29 vac is good). replace the transformer if necessary.
Disconnect the sensor harness from the board. If no change to the display, then the board has been damaged by the power surge. If the display is restored, then replace the sensor harness.
0 Replies
 
 

Related Topics

Nitrite in softwater - Question by GTR
Rain soft Q2 no water in brine tank - Question by frbird400
Very, Very Strange Water Softner issue - Question by iamarinog
Need 3/4" plug for Rainsoft Q2 water softener - Question by jimg972
What kind of fitting do I use to connect to my Rainsoft EC4? - Question by jberenyi
Rainsoft 2000 brass valve rebuild - Question by Mdhwoods
Hard water after new resin - Question by tristanlee85
Is it OK to use salt pellets in Autotrol 1550TC water softener? - Question by kzhao
reseting - Question by Thomas63
Why is my water softener squealing and shaking? - Question by JamieThompson
Low water pressure with Q2 valve rainsoft - Question by stolidmind
 
  1. Forums
  2. » ecowater systems
Copyright © 2024 MadLab, LLC :: Terms of Service :: Privacy Policy :: Page generated in 0.04 seconds on 12/28/2024 at 07:24:50
▲ ▼