Reply Sat 25 Jul, 2015 05:37 pm
Halogen went out after ~15 years. Bought replacement bulb. Installed but would not go on. Assumed it was the receptacle. Bought a replacement QRX-6.35C. Here is where I am stuck. Original connects via a male flat metal prong to a female receiver. Replacement is just bare leads. Is there some kit that will allow me to mount the bare leads to these flat prongs or is there a specific receptacle that I require. It sure looks like the original had the prongs attached and some shrink plastic wrapper was applied to lock it into place.
  • Topic Stats
  • Top Replies
  • Link to this Topic
Type: Question • Score: 0 • Views: 1,163 • Replies: 0
No top replies

 
 

 
  1. Forums
  2. » 2 pin halogen
Copyright © 2024 MadLab, LLC :: Terms of Service :: Privacy Policy :: Page generated in 0.07 seconds on 12/03/2024 at 03:31:40