Sun 5 Jul, 2015 12:47 pm - the cams are actually keyed to fit on the shaft. walking it through a manual mode should automatically reset it into the "in service mode". or just unplug and plug it back in .
(view)
Sun 5 Jul, 2015 12:41 pm - water should not run during the 120 minute 2nd part of the regen cycle. It should just sit there and look pretty while it's making brine. The new seals should fix the problem. If you're... (view)
Sun 5 Jul, 2015 12:22 pm - if the drive motor is running all the time and the white cams aren't turning the you need a shear pin and orings replaced. if the cams are turning you have a bad switch or loose connecter on a... (view)
Sun 5 Jul, 2015 12:10 pm - poppet on the bottom of the clear plastic viewer between the brass elbow and the clear plastic viewer is bad or missing, or lines on the clear plastic viewer are reversed.
(view)
Sun 5 Jul, 2015 12:04 pm - stage 3 is backwash, no water sucked from the brine tank. 5 is when the brine water is used to clean/regenerate the resin. when the system is giving you soft water, the clear tri-guard in the... (view)
Mon 12 May, 2014 12:30 pm - I'm not sure which buttons aren't working on your unit in reading both of your posts, but you can try replacing the battery after unplugging the unit. The warranty on electrical is... (view)
Mon 12 May, 2014 12:21 pm - you could try unplugging the unit,remove the battery let it sit for a minute, replace the battery with a new one, plug it back in. of course you will have to reset everything and if the red... (view)
Tue 1 Apr, 2014 12:29 pm - the system doesn't regenerate every night(hopefully) so without knowing what you did, I can only guess that you are missing the poppet valve ,below the triguard and that the two lines on the... (view)
Sat 15 Jun, 2013 02:29 pm - I know it's a little late , but in looking at the pictures, shouldn't the brine line from the brine tank be attached to the top connector? (view)
